User's Manual

Quick Tour
ZOOM MRS-8
22
• LINE
An algorithm suitable mainly for recording line-level
output instruments such as synthesizer or electric piano.
• Dual MIC
An algorithm for two entirely separate mono input and
mono output channels, for use with two microphones.
• MASTERING (shown on the display as
“MASTRING”)
An algorithm suitable for processing the final stereo
mixdown signal.
HINT
In the default condition of a project, the CLEAN algorithm is
selected for the insert effect.
NOTE
When a patch of the CLEAN, DIST, ACO/BASS SIM, or BASS
algorithms is selected, the built-in mic cannot be used. But
when the insert effect is temporarily bypassed, when
“CABINET” is selected on the PRE AMP/DRIVE module, or
when the module is turned off, you can use the built-in mic.
4.
Set the [MASTER] fader to 0 (dB). While
playing your instrument to check the
sound, use the dial to select the patch.
300 patches can be used with the insert effect. The effect
type and intensity for a patch can be adjusted as needed.
The patches available with the different algorithms are
listed below.
HINT
When “EMPTY” is shown as the patch name, the patch is
empty. Selecting such a patch will have no effect.
NOTE
Depending on the selected algorithm, the input/output signal
routing will change (
→
p. 94).
5.
To adjust the signal level recorded on a
track, press the [TRACK PARAMETER] key
in the control section and then press the
INPUT [ON/OFF] key.
The insert effect output level may change according to the
selected patch. When recording with the insert effect
applied, you will have to adjust the recording level
according to the selected patch.
6.
Press the cursor down key repeatedly to
bring up the indication “REC LVL” on the
second line of the display.
The display changes as follows. The REC LVL parameter
shown on this screen indicates the signal level after
passing the insert effect, which will be recorded on the
track.
7.
Turn the dial to adjust the recording level.
8.
To return to the main screen, press the
[EXIT] key.
HINT
•To record without using the insert effect, press the [INSERT
EFFECT] key in the effect section repeatedly until the key goes
out. While the key is out, the insert effect is bypassed.
Algorithm
Patch number
CLEAN
0 – 29
DIST
0 – 49
ACO/BASS SIM
0 – 19
BASS
0 – 19
MIC
0 – 49
LINE
0 – 49
DUAL MIC
0 – 49
MASTERING
0 – 29
0 dB
INPUT
INPUT
REC LVL
REC LVL
100
MRS-8(E).book 22 ページ ２００４年７月３０日 金曜日 午後５時２４分