User's Manual

Quick Tour
ZOOM MRS-8
26
Step 4: Mixing
When you have finished recording all tracks, you can use
the built-in mixer to adjust parameters such as volume
level, EQ (equalizer), and panning (stereo left/right
positioning) to create the stereo mix.
Adjust the volume, panning, and equalization for each
track by controlling the track parameters of the built-in
mixer.
1.
To adjust the volume balance between
tracks, operate the faders in the fader
section.
By operating the faders of a pair of stereo tracks, you can
adjust the left/right level together.
To add the drum/bass track to the mix, operate the
[RHYTHM] fader after switching the [DRUM/BASS]
key between lit (drum track selected) and out (bass track
selected). This will adjust the drum/bass track mixing
balance.
To control the mute/on status, select the drum or bass
track with the [DRUM/BASS] key and then press the
[RHYTHM] status key.
The signal level for each track can be checked with the
respective bars in the display.
NOTE
In some cases, the current fader position may not match the
volume setting value for a track stored in a project (such as
when the fader was moved for another project and then the
previous project was called again). In such a case, the
volume may not change until the fader setting has been
changed to a certain extent.
2.
If an input signal is not required, press the
lit INPUT [ON/OFF] key so that the key goes
out.
While the INPUT [ON/OFF] key is lit, the signal from
that input will be added to the stereo mix. If the input
signal is not required, the key should be turned off.
3.
To adjust EQ and panning for each track,
press the [TRACK PARAMETER] key in the
display section.
You now can adjust various track parameters such as
equalization and panning for each track.
4.
Use the cursor left/right keys or the status
keys to select the track for which you want
to make a setting.
The status key for the currently selected track is lit in
orange.
While a track parameter is shown, you can use the status
keys and cursor left/right keys to switch tracks. The
cursor left/right keys cycle through the following
selections: drum track
→
bass track
→
audio track 1 – 8.
5.
Use the cursor up/down keys to bring up
the parameter that you want to adjust.
4.1 Adjusting volume,
panning, and EQ
Track 1 – 8 signal level
TR2
TR2
EQ HI G
EQ HI G
0
Lit in orange
TR2
TR2
PAN
PAN
0
MRS-8(E).book 26 ページ ２００４年７月３０日 金曜日 午後５時２４分