User's Manual

Reference [Track Editing]
ZOOM MRS-8
51
You can erase the audio data on a specified V-take. The V-
take is returned to the non-recorded condition.
1.
Refer to steps 1 – 5 of “Basic steps for V-
take editing” to select the track/V-take to
erase and to bring up the indication
“ERASE” on the display. Then press the
[ENTER] key.
The indication “ERASE SURE?” appears on the display.
2.
To carry out the erase operation, press the
[ENTER] key once more.
The V-take name changes to “NO DATA” and the V-take
reverts to the non-recorded condition. When the erase
operation is completed, the V-take selection screen
appears again.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
You can copy the audio data of a specified V-take to any
other V-take. This action will overwrite any existing data
on the destination V-take. The data on the copy source V-
take will be unchanged.
1.
Refer to steps 1 – 5 of “Basic steps for V-
take editing” to select the track/V-take to
copy and to bring up the indication “COPY”
on the display. Then press the [ENTER] key.
The display changes as follows. In this condition, you can
specify the copy destination track/V-take.
HINT
If nothing is recorded on the V-take selected as editing
destination, the indication “E” is shown next to the V-take
number.
2.
Use the cursor left/right keys or the status
keys and the dial to select the destination
track/V-take, and press the [ENTER] key.
If no audio data exist at the copy destination, the
indication “COPY SURE?” appears on the display. If
audio data exist, the indication “OverWrt?” is shown.
When the copy operation is performed, these data will be
overwritten.
3.
To carry out the copy operation, press the
[ENTER] key once more.
When the copy operation is completed, the unit returns to
the V-take selection menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
You can move the audio data of a specified V-take to any
other track/V-take. This action will overwrite any existing
data on the destination V-take. The data on the move
source V-take will be erased.
1.
Refer to steps 1 – 5 of “Basic steps for V-
take editing” to select the track/V-take to
move and to bring up the indication
“MOVE” on the display. Then press the
[ENTER] key.
The display changes as follows. In this condition, you can
specify the move destination track/V-take.
HINT
If nothing is recorded on the V-take selected as editing
Erasing a V-take
Copying a V-take
Erase
Copy source track
Copy destination track
Copy
COPY TO
COPY TO
TR 1- 2E
TR 1- 2E
Moving a V-take
Move source track
Move destination track
Move
MOVE TO
MOVE TO
TR 1- 2E
TR 1- 2E
MRS-8(E).book 51 ページ ２００４年７月３０日 金曜日 午後５時２４分