User's Manual

Reference [Track Editing]
ZOOM MRS-8
52
destination, the indication “E” is shown next to the V-take
number.
2.
Use the cursor left/right keys or the status
keys and the dial to select the destination
track/V-take, and press the [ENTER] key.
If no audio data exist at the move destination, the
indication “MOVE SURE?” appears on the display. If
audio data exist, the indication “OverWrt?” is shown.
When the move operation is performed, these data will be
overwritten.
3.
To carry out the move operation, press the
[ENTER] key once more.
When the move operation is completed, the unit returns
to the V-take selection menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
You can exchange the audio data of two specified V-takes.
NOTE
You cannot exchange V-takes of the master track.
1.
Refer to steps 1 – 5 of “Basic steps for V-
take editing” to select the track/V-take to
exchange and to bring up the indication
“EXCHG” on the display. Then press the
[ENTER] key.
You can now select the other track/V-take.
2.
Use the cursor left/right keys or the status
keys and the dial to select the exchange
destination track/V-take, and press the
[ENTER] key.
The indication “EXCHG SURE?” appears on the display.
3.
To carry out the exchange operation, press
the [ENTER] key once more.
When the exchange operation is completed, the unit
returns to the V-take selection menu.
By pressing the [EXIT] key instead of the [ENTER] key,
you can cancel the operation and back up one step at a
time.
You can import any V-take from another project into a
specified track/V-take of the current project. Any audio
data on the destination V-take are overwritten by the
imported V-take.
NOTE
The master track cannot be specified as import destination
or import source.
1.
Refer to steps 1 – 5 of “Basic steps for V-
take editing” to select the import
destination track/V-take and to bring up the
indication “IMPORT” on the display. Then
press the [ENTER] key.
The name of the import source project is shown on the
display.
2.
Turn the dial to select the import source
project, and press the [ENTER] key.
The display changes as follows. In this condition, you can
specify the import source track/V-take.
Exchanging V-takes
Exchange
EXCHG TO
EXCHG TO
TR 1- 3
TR 1- 3
Importing a V-take from
another project
Track of import source project
Import destination track
Import
IMPORT
IMPORT
PRJ002
PRJ002
2
Project numbe
r
Import source project name
MRS-8(E).book 52 ページ ２００４年７月３０日 金曜日 午後５時２４分