User's Manual

Reference [Mixer]
ZOOM MRS-8
56
If no recording track is selected, the signal from the
inputs can be sent to the mixer and mixed to the output
signal during bounce and mixdown. In this case, track
parameters such as panning and send/return effect depth
can be set for the input signal.
Assigning input signals to
recording tracks
This section explains how to select the input source signal
from the INPUT 1/2 connectors and the built-in
microphone, and how to send it to the audio tracks for
recording.
The MRS-8 allows you to select up to two signals from
the INPUT 1/2 connectors and the built-in mic. The
INPUT 1 connector and the built-in mic are switchable,
and one of these can be used at a time. The following
combinations are possible.
NOTE
• The built-in mic can normally only be used when an algorithm
other than CLEAN, DIST, or ACO/BS SIM is selected for the
insert effect.
• When the PRE AMP/DRIVE module is set to CABINET or OFF,
the built-in mic can be used also when one of the above
algorithms is selected for the insert effect.
• The status of the [MIC] key indicates whether the built-in mic
can be used. When the key is flashing, the mic can be used.
When the key is out, the mic cannot be used.
1.
When using the INPUT 1/2 connectors,
make sure that the instrument or mic that is
to be recorded is connected to the
respective input.
NOTE
When using the INPUT 1 connector, the [INPUT1 SELECT]
switch on the rear panel must be set to the correct position
for the instrument.
2.
Select the input source as follows.
The input source selection is made using the INPUT
[ON/OFF] 1/2 keys and the [MIC] key. Repeatedly
pressing a key toggles between the lit/out (or flashing)
conditions.
• Selecting one INPUT connector
Verify that the [MIC] key is flashing or out. Then press
the INPUT [ON/OFF] key for the connector to which the
instrument is connected, so that the key is lit.
• Selecting two INPUT connectors
Verify that the [MIC] key is not lit. Then press one
INPUT [ON/OFF] key so that the key is lit. Next, hold
down the lit INPUT [ON/OFF] key and press the other
INPUT [ON/OFF] key.
• Selecting only the built-in mic
Press the [MIC] key so that the key is lit. Then press the
INPUT [ON/OFF] 1 key so that the key is lit.
Input source
Signal type
INPUT 1 connector Mono
INPUT 2 connector Mono
Built-in mic Mono
INPUT 1/2 connectors Stereo
Built-in mic + INPUT 2
connector
Stereo
INPUT [ON/OFF] key
INPUT
[ON/OFF]
key
INPUT
[ON/OFF]
key
INPUT
[ON/OFF]
key
[MIC] key
MRS-8(E).book 56 ページ ２００４年７月３０日 金曜日 午後５時２４分