User's Manual

Reference [Mixer]
ZOOM MRS-8
60
NOTE
When the recording track is selected, the input signal does
not pass through the mixer but is supplied directly to the
track. Therefore, if a track is in recording standby mode, the
input track parameter settings will have no effect. (However,
the REC LVL parameter is always active.)
4.
Turn the dial to adjust the value.
5.
To switch EQ HI, EQ LO, or effect send
between on and off, select the respective
parameter (marked with an asterisk in the
table on the previous page) and press the
[ENTER] key.
Each push of the [ENTER] key toggles between on and
off. For example, when switching EQ HI from on to off,
the display changes as follows.
• On condition
•Off condition
6.
Repeat steps 3 – 5 until all desired
parameters are adjusted.
If required, you can use the cursor left/right keys or the
status keys to change to another track and adjust its
parameters. This is useful to adjust the same parameter
for several tracks.
7.
To return to the main screen, press the
[EXIT] key.
Linking two tracks
(stereo link)
In the MRS-8, the parameters of adjacent odd-numbered/
even-numbered mono tracks (1/2 or 3/4) can be linked,
resulting in a pair of stereo tracks. This function is
referred to as “stereo link”. The setting procedure is as
follows.
1.
From the main screen, press the [TRACK
PARAMETER] key in the display section
2.
Use the cursor left/right keys or the status
keys to select one of the two tracks to
stereo-link.
3.
Use the cursor up/down keys to bring up
the following indication on the display.
4.
Turn the dial to set the parameter to ON.
Stereo linking will be enabled immediately, so that the
selected track and the adjacent odd-numbered/even-
numbered track are linked. To defeat stereo linking,
return the setting to OFF.
When stereo link is on, track operation will be as follows.
•To adjust the track volume, use the odd-numbered
fader. (The even-numbered fader will have no
effect.)
• The PAN parameter of two stereo-linked tracks will
function as a balance parameter that adjusts the
volume balance between the tracks.
• Except for PAN and V-TAKE, the track parameters
for the odd-numbered track will also apply to the
even-numbered track.
5.
To return to the main screen, press the
[EXIT] key.
TR1
TR1
EQ HI G
EQ HI G
4
TR1
TR1
EQ HI
EQ HI
OFF
TR1
TR1
ST LINK
ST LINK
OFF
TR1/2
TR1/2
ST LINK
ST LINK
ON
MRS-8(E).book 60 ページ ２００４年７月３０日 金曜日 午後５時２４分