User's Manual

Reference [Effects]
ZOOM MRS-8
93
Each effect module in an algorithm comprises two
aspects, namely the effect type and the effect parameters.
Even within the same algorithm, changing the effect type
and/or the effect parameters can produce a variety of
different sounds.
The edited effect type and parameter settings are stored as
a so-called “patch”. The insert effect allows 20 – 50
patches per algorithm. The numbers are listed in the table
below.
To use a patch, first select the algorithm and then select
one of the patches in the algorithm. When you select a
patch, it becomes effective immediately.
In the default condition of a project, the insert effect is
applied immediately after the input. To change the insert
location, proceed as follows.
1.
From the main screen, press the [INPUT
SRC] key in the effect section.
The current insert position is shown on the display.
The display meaning is as follows.
• IN
Immediately after input (default)
• DRUM
Drum track
• BASS
Bass track
• TR 1 – 4
Tracks 1 – 4
• TR 1/2, TR 3/4, TR 5/6, TR 7/8
Mono tracks x 2 (tracks 1/2, 3/4) or stereo tracks (tracks
5/6, 7/8)
• MASTER
Immediately before [MASTER] fader
2.
Turn the dial to select the insert position.
HINT
While the screen of step 1 is shown, the status keys and
INPUT [ON/OFF] keys 1/2 can also be used to select the
insert position. To select the track pairs 1/2 and 3/4, press
both status keys together. To select the drum/bass track
using the status key method, press the [RHYTHM] status key
repeatedly until the desired insert position (“DRUM” or
“BASS”) is shown.
3.
When the desired insert position has been
selected, press the [EXIT] key to return to
the main screen.
This section explains how to select the patch for the insert
effect.
1.
From the main screen, press the [INSERT
EFFECT] key in the effect section
repeatedly, until the key is lit.
The following display is shown. In this condition, you
can select the algorithm and patch for the insert effect.
Algorithm
Number of patches
(preprogrammed patches)
CLEAN 30 (22)
DIST 50 (42)
ACO/BASS SIM 20 (10)
BASS 20 (10)
MIC 50 (31)
LINE 50 (30)
DUAL MIC 50 (30)
MASTERING 30 (21)
Changing the insert location
of the insert effect
Patch
COMP
PRE AMP/
DRIVE
EQ
ZNR
PAT LVL
MODULATION/
DELAY
IN SRC
IN SRC
IN
IN
Insert position
Selecting the patch for the
insert effect
MRS-8(E).book 93 ページ ２００４年７月３０日 金曜日 午後５時２４分