User's Manual

Reference [Effects]
ZOOM MRS-8
98
An insert effect patch that you have edited can be stored
in any location of the same algorithm. By storing an
existing patch in another location, you can create a copy
of that patch. Interchanging the position of patches
(swapping) is also possible.
1.
From the insert effect patch selection
screen or the edit screen, press the
[FUNCTION] key.
The currently selected patch goes into store standby
mode. In this condition, you can select whether to
perform store or swap.
2.
Use the cursor left/right keys to bring up
the indication “STORE TO” or “SWAP TO”.
3.
Turn the dial to select the number of the
patch to store/swap.
When carrying out store, the current patch settings will be
stored under this number.
When carrying out swap, the currently selected patch and
the patch settings selected here will be interchanged.
4.
To carry out the store/swap operation,
press the [FUNCTION] key.
When the store/swap operation is completed, the insert
effect patch selection screen appears again.
By pressing the [EXIT] key instead of the [FUNCTION]
key, you can cancel the operation and back up one step at
a time.
HINT
• Patches are saved as part of a project.
• Patches from another project can be imported to the current
project ( →
p. 102).
This section explains how to assign a name to the
currently selected insert effect patch.
1.
From the insert effect patch selection
screen, select the patch whose name you
want to change.
2.
Press the [EDIT] key.
The selected patch can now be edited.
3.
Use the cursor left/right keys to bring up
the indication “TOTAL PAT LVL” on the
display.
4.
Repeatedly press the cursor down key to
bring up the indication “PAT NAME” on the
display.
The name of the selected patch can now be edited. The
cursor indicates the character that can be changed.
5.
Use the cursor left/right keys to move the
cursor to the character you want to change,
and turn the dial or use the rhythm section
pads and keys to select a character.
For information on how to input characters, refer to page
33.
6.
To confirm the new name, press the
[FUNCTION] key in the control section
twice.
The patch is stored, overwriting the old information.
When storing is complete, the insert effect patch selection
screen appears again.
Storing or swapping insert
effect patches
STORE TO
STORE TO
Standard
Standard
0
Patch number
Assigning a name to an insert
effect patch
CLEAN
CLEAN
Standard
Standard
0
TOTAL
TOTAL
PAT LVL
PAT LVL
25
PAT NAME
PAT NAME
±tandard
tandard
Cursor
MRS-8(E).book 98 ページ ２００４年７月３０日 金曜日 午後５時２４分