User's Manual

Reference [Effects]
ZOOM MRS-8
99
NOTE
Keep in mind that the name will revert to the previous name
if you switch to another patch without storing the edited
patch.
Normally, when the insert effect is applied immediately
after the input, the signal processed by the effect will be
recorded (effect recording). If necessary, however, you
can apply the insert effect only to the monitor signal, and
record the unprocessed input signal on the track.
For example when recording the unprocessed sound of a
vocal performance, the vocalist may be more comfortable
singing if an effect is applied to the monitor signal only.
1.
Set the insert effect position to immediately
after the input.
2.
From the main screen, press the [SYSTEM/
UTILITY] key in the display section.
The indication “SYSTEM PROJECT” appears on the
display.
3.
Use the cursor left/right keys to bring up
the indication “SYSTEM REC SRC” on the
display, and press the [ENTER] key.
The display changes as follows.
You can now select one of the following two signal types
to be recorded on the track.
• WET
The input signal that has passed through the insert effect
will be recorded on the track (default setting).
•DRY
Only the unprocessed input signal will be recorded on the
track. If the insert effect is applied to the input, the signal
appearing at the MASTER OUTPUT jacks will be
processed by the effect.
4.
Turn the dial to change the setting to
“DRY”.
5.
When you have finished making settings,
press the [EXIT] key repeatedly to return to
the main screen.
NOTE
This setting is stored for each project. If required, change the
setting back to “WET” before you begin recording other
parts.
Applying the insert effect only
to the monitor signal
SYSTEM
SYSTEM
PROJECT
PROJECT
REC SRC
REC SRC
WET
WET
MASTER 1
Fader 1
[MASTER] fader
MASTER
OUTPUT
jacks
Insert
effect
Track 1
MASTER 1
Fader 1
[MASTER] fader
MASTER
OUTPUT
jacks
Insert
effect
Track 1
MRS-8(E).book 99 ページ ２００４年７月３０日 金曜日 午後５時２４分