Specifications

ZOOM PS-04 11
Operating the Unit on Batteries
The PS-04 can be operated on battery power. Purchase the
correct batteries and insert them as described below.
1. Turn the PS-04 over and open the cover of
the battery compartment.
2. Insert four IEC R6 (size AA) batteries into
the compartment. (Use alkaline batteries.)
3. Close the cover of the battery compartment.
N OTE
When the PS-04 is operating on battery
power and the batteries are getting low, the indication "BATT" will appear on the display.
Replace all four batteries with fresh ones as soon as possible.
Power On/Off
To turn the PS-04 on and off, proceed as follows.
■ Power-on
1. Verify that power to the PS-04 and all connected equipment is off.
The volume controls of the connected instrument, PS-04, and the monitoring
system should be turned fully down.
2. Insert the SmartMedia card into the card slot (
➔
p. 10).
3. Set the [ON/OFF] switch on the side panel of the PS-04
to "ON".
The indication "PS-04" appears on the display and the PS-04 starts up.
4. Turn power to the connected instrument and the
monitoring system on in that order.
■ Power-off
5. Turn power to the monitoring system and the connected
instrument off in that order.
6. Set the [ON/OFF] switch on the side panel of the PS-04 to "OFF".
The indication "GOODBYE" is briefly shown on the display and the PS-04 is shut down.
N OTE
Never turn the PS-04 off by disconnecting the AC adapter. Otherwise data loss may occur.
C aution
When using the AC adapter, always use the [ON/OFF] switch on the side panel of the
PS-04 to turn power on and off. Be especially careful when the card access indicator is lit.
Disconnecting the AC adapter in such a case may lead to fatal data loss.
PS-04 side panel
[ON/OFF] switch
Bottom of PS-04
Battery
compartment
cover
Battery
compartment
IEC R6 (size AA)
battery x 4