Specifications

Reference [Mixer]
54 ZOOM PS-04
The track parameter menu for making input and
track 1 – 4 settings appears.
2. Use the cursor left/right keys to bring
up the indication “INPUT SEL” on the
display.
The indication “INPUT SEL” is briefly shown on
the display, and then the input source display
appears.
H INT
The “REC” indications on the display
correspond to the built-in mic, [INPUT] jack,
and [LINE IN] jack. When the indication is
constantly on, the source is selected (active).
Otherwise the indication is flashing.
3. Use the status keys 1 – 4 to select the
input source.
To select a single input source, press one of the
status keys 1 – 4. To select two input sources, press
the status keys for the two sources simultaneously.
Possible input source combinations are listed in the
table below.
H INT
• The [LINE IN] signal can be selected by
pressing only one of the status keys 3 or 4.
• When combining the [LINE IN] signal with
another input source, the L and R
components of the signal at the [LINE IN] jack
are mixed to produce a mono signal.
4. When the [INPUT] jack was selected
as input source, play the instrument
and adjust the input sensitivity with
the [INPUT LEVEL] knob so that the
sound is not distorted when playing
the instrument at maximum level.
If the indication “-PEAK-” is shown on the display,
signal distortion has occurred.
5. To adjust the recording level, play the
instrument and adjust the fader for
the selected input source.
While the input track parameter display is shown,
you can use faders 1 – 4 to adjust the recording
level for each source. You can check the current
level using the setting value shown on the display
and the level meter.
When two sources are selected, use the up/down
cursor keys to select either to be adjusted.
If signal distortion occurs, the topmost segment of
the level meter will stay on for a while. Use the
fader to reduce the recording level setting for that
source.
MIC
MIC
Currently selected input source
(built-in mic in this example)
RECLVL
RECLVL
100
Status key Display
Input source
Input 1 Input 2
1 MIC Built-in mic
2 INPUT [INPUT] jack
3 or 4 LINE [LINE IN] jack L [LINE IN] jack R
1+2 MIC+INPUT Built-in mic [INPUT] jack
1 + 3 or 1 + 4 MIC+LINE Built-in mic [LINE IN] jack L + R
2 + 3 or 2 + 4 LIN+INPUT [LINE IN] jack L + R [INPUT] jack