Specifications

SONG mode operation
ZOOM PS-04 79
13245
PATTERN 001 PATTERN 020
D maj G min A7
BPM-135
STNDRD
FINGER SLAP
10
10
4/4
Measure
Pattern
Beat
Root / Chord
Tempo
Drum track volume
Bass track volume
Drum kit
Bass program
If required, you can change the chord information in
the middle of in a pattern and measure, as shown
below. To do this, return to the current position
screen, turn the dial to specify the current position in
measure/beat units, and then call up the chord
information input screen again.
9. Repeat steps 5 – 8 and enter the
remaining chord information.
If you have made a mistake, or if you want to
change something, proceed as follows.
● Changing chord information
Move the current position to the point where you
want to make the change. Then press the cursor
[W] key repeatedly to bring up the chord
information input screen, and use the dial to change
the chord information.
● Erasing chord information
Move the current position to the point from where
you want to delete chord information. Then press
the cursor [W] key repeatedly to bring up the chord
information input screen, and press the [EDIT/
UTILITY] key. This returns the point to the
"←ROOT" or "←CHORD" condition (preceding
chord information is used).
10 . To terminate the input, press the
[REC] key.
The [REC] key goes out, and the SONG mode top
screen returns. By pressing the [R/P] key, you can
play the finished song to check the result.
Entering other event information
A song consists of various event information
including pattern, chord, tempo, and beat. A song
can be thought of as a matrix like the one shown
below. When song input is activated ([REC] key is
lit), the cursor left/right keys and the dial can be
used to move the current position, and the cursor
up/down keys can be used to call up the desired
event for inputting a new event, or editing the event
information.
1 2341234
1
Em
3
Em
2
Am
4
AmB7
PATTERN A
12 3 4 12 3 4
PATTERN B
Beat
Measure