Owner's Manual
Table Of Contents
- Operation Manual
- Introduction
- Contents
- Names of parts
- Preparations
- Recording
- Playing recordings
- Managing files
- Using USB functions
- Battery settings
- Setting the date and time
- Setting the volume of the operation sound
- Enabling continuous playback
- Using mics that support plug-in power
- Setting the standard frame rate
- Setting the language shown
- Formatting microSD cards
- Restoring factory default settings
- Updating the firmware
- Responding to warning messages
- Troubleshooting
- Specifications
- Quick Guide
- Included Items
- Optional Accessories
- About Recommended Batteries
- About Writing Speed of the MicroSD Card
- Q2n-4K Operation Confirmed micro SDHC/SDXC Cards
- Safety and Usage Precautions
- Warranty
Setting low-frequency noise reduction
The low-cut filter can be set to reduce the sound of wind, vocal pops and other noise.
1.
Press
LO CUT
on the Recording Screen to set the low-frequency noise reduction.
LO CUTVIDEO
AUDIOFOV
AUTO GAIN
SCENE
EXIT
Setting Explanation
OFF Low-frequency noise reduction is disabled.
80 Hz
These set the cutoff frequency.120 Hz
160 Hz
NOTE
The higher the cutoff frequency is set, the stronger the low-frequency noise reduction effect will be.
Since this also affects other low-frequency sounds, though, check the effect while you are making this
setting.
Setting the audio quality
This sets the sampling frequency (kHz) and bit rate.
1.
Press
AUDIO
on the Recording Screen to set the audio quality.
LO CUTVIDEO
AUDIOFOV
AUTO GAIN
SCENE
EXIT
Setting Explanation Audio quality File size
44.1 kHz/16-bit
The higher the sampling frequency (kHz) and bit rate
are set, the better the audio quality will be.
Low Small
48 kHz/24-bit
96 kHz/24-bit
High Large
20
□]
□]
□]
□]
C]
□]
1
■
1
ul
[□
[□
[□
[Q]
[□
t t
t t