Operation Manual

ZOOM RFX-2200
9
With each push of the PARM CHECK key, the parameter
to be checked is advanced successively.
REV CHARACTER
Parameter adjusted with REV CHARACTER (EDIT 1)
control
REV TIME
Parameter adjusted with REV TIME (EDIT 2) control
REV EQ LOW
Parameter adjusted with REV EQ LOW (EDIT 3) control
REV EQ HIGH
Parameter adjusted with REV EQ HIGH (EDIT 4) control
MIX
Mixing balance of original sound and effect sound
TAP BEAT
Length of reference beat for tap input
• The TAP BEAT parameter can only be checked when an
effect is selected for which the tap input function (see
below) can be used. However, when RHYTHMIC DELAY
is selected, there is no tap beat setting.
• When checking the rate parameter set with the tap
function, the indication "tP" is shown on the display.
Useful Functions
Comparing the Sound Before and After Edit (Compare Function)
1. Press the COMPARE key.
The currently edited patch is temporarily returned to the
condition before editing. The indication "CP" and the
patch number flash alternately on the display, and the
"EDITED" mark is out.
2. To return to editing, press the COMPARE key
once more (or press the CANCEL key).
• If desired, you can check the original value of each
parameter by pressing the PARM CHECK key while the
unit is in the compare mode.
• Moving any of the controls in compare mode has no
effect.
Shown
alternately
COMPARE key
Setting Parameters With the Tap Key (Tap Input)
1. Select a patch for which tap input is possible.
Whether tap input is possible or not depends on the effect
selected for that patch (see pages 14 - 22). When a patch
for which tap input is possible is selected, the TAP LED
flashes.
2. Hit the TAP key several times in the desired
interval.
The delay time or rate is set according to the tap interval
and the tap beat parameter set for the respective patch
(see page 12).
3. If desired, store the patch.
The parameter changed by tap input will revert to the
original setting when the patch is switched. To retain the
change, you should therefore store the patch.
• The parameter which can be set by tap input is preset
(see pages 14 - 22).
• The maximum interval that can be measured by the tap
input function is 2 seconds.
• If the tap input interval is outside the setting range for
that parameter, it will be corrected to an acceptable
value.
• If a parameter was set by tap input and is then changed
by moving the control knob for that parameter, the
control knob setting will override the tap input.
This function allows you to compare the currently edited sound to the sound before editing.
The RFX-2200 allows input of time-based parameters by tapping the TAP key at the desired intervals. For example, the flanger
modulation speed or delay time can be easily matched to the tempo of a song in this way.