User Manual

134
Setting timecode initialization used at startup
1. Press .
2. Use and to select
TIMECODE, and press
.
3. Use and to select
Start TC, and press
.
▶ Continue to one of the following procedures.
Setting how timecode is initialized at startup
(Start Timecode) ……………………………………………………………… P.134
Correcting timecode errors after the power has been
turned off…………………………………………………………………………… P.135
■ Setting how timecode is initialized at startup
4. Use and to select
Mode, and press
.
5. Use and to set
how timecode is initial-
ized, and press
.
Setting Explanation
Restart Time
When the
starts, the value set by Restart ( → P.131) is
used to jam the internal timecode.
RTC
When the
starts, its timecode is restored from the time-
code when the power was turned off and advanced by the
elapsed time using the Date/Time (RTC) setting ( →P.18).
Since RTC is less precise than internal timecode, discrepan-
cies will occur.
When the is turned off, the internal timecode stops, so the timecode is automatically initialized (jammed) during startup. The value that is used
for jamming at that time can be set.