User Manual

88
■ Setting the attack time
This sets the amount of time until compression starts after the input
signal exceeds the threshold.
7. Use and to select
Attack Time, and press
.
8. Use and to adjust
the time, and press
.
HINT
This can be set from 1 to 4 ms.
NOTE
This setting becomes available when On/Off is set to On (Normal).
■ Setting the release time
This sets the amount of time until compression stops after the input
signal goes below the threshold.
7. Use and to select
Release Time, and press
.
8. Use and to adjust
the time, and press
.
HINT
Limiter operation is linked for tracks that have stereo link or MS stereo link
enabled. If the signal for either linked channel reaches the threshold, the
limiter will operate on both tracks.
NOTE
This setting becomes available when On/Off is set to On (Normal).