User Manual

Timecode
Setting timecode initialization used at startup (Start Timecode)
134
Setting timecode initialization used at startup (Start Timecode)
Since internal timecode stops when the is turned off, the timecode is automatically initialized (jammed) during startup. You
can set the value that is used for jamming at that time.
1. Press .
2. Use to select TIMECODE ,
and press
.
3. Use to select Start
Timecode
, and press .
▶ Continue to one of the following procedures.
Setting how timecode is initialized at startup .................P.134
Correcting timecode errors after the power has been
turned off .........................................................................P.135
Setting how timecode is initialized at startup
4. Use to select Mode , and
press
.
5. Use to set how timecode
is initialized, and press
.
Setting value Explanation
Restart Time
When the
starts, the value set by Restart (→ P.132) is
used to jam the internal timecode.
RTC
When the
starts, its timecode is restored from the
timecode when the power was turned off and advanced by
the elapsed time using the Date/Time (RTC) setting
(→ P.19).
Since RTC is less precise than internal timecode, discrep-
ancies will occur.