User Manual

Using the limiter
5. Use to select On/Off ,
and press
.
6. Use to select the
setting, and press
.
Setting value Explanation
Off This disables the limiter.
On (Normal) This applies an ordinary limiter. The ratio is 20:1.
On (Advanced)
By detecting the maximum level in advance, this optimized
limiter prevents distortion even more than ordinary limiter
operation. The ratio is ∞:1, providing increased internal
headroom.
NOTE
When set to On (Advanced), the input latency of the
increases
1 ms. When monitoring sounds being recorded with a mic in real-
time, increased latency can cause interference between sound
transmitted through the air from the source and the delayed mon-
itored sound, possibly making accurate monitoring of the sounds
difficult.
▶ Continue to one of the following procedures.
Using the limiter ................................................................P.84
Setting the type .................................................................P.85
Setting the threshold .........................................................P.86
Setting the attack time.......................................................P.86
Setting the release time ....................................................P.87
Setting the target level ......................................................P.88
On (Normal)
On (Advanced)
Before limiter After limiter
Peak might remain
Before limiter After limiter
threshold
target
level
Sudden peaks are
suppressed by detecting
maximum levels in advance
Input settings
Input limiter
84
Input limiter (continued)