User manual Washing Machine P 710
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Consumption valu
• Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Use • This appliance is designed for domestic use. It must not be used for purposes other than those for which it was designed. • Only wash fabrics which are designed to be machine washed. Follow the instructions on each garment label. • Do not overload the appliance. See the Washing Programme Table.
Product description 1 2 3 4 5 6 Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet 1 2 3 4 5 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Flap for powder or liquid detergent (see "Flap for powder or liquid detergent" in the chapter "Daily use" for more details). Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages.
Available options: Spin reduction button (Centrifuga) Press the spin reduction button to change the spin speed of the selected programme or to select «Antipiega» or «Esclusione Centrifuga» option. Esclusione Centrifuga By selecting this option, all spinning phases are suppressed and replaced by a drain, so as not to wrinkle the laundry. Recommended for extremely delicate fabrics. On some programmes the rinses will be performed with more water. this option. Some additional rinses will be performed.
Daily use Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Measure out the detergent and the fabric softener DOWN - The flap position if using LIQUID detergent during main wash If the flap is not in the desired position: • Pull out the dispenser drawer until it stops. The flap is down and you wish to use powder detergent: • Turn the flap up.
• Turn the flap down. Select the required temperature by turning the temperature selector dial (2) Turn clockwise this dial to select the more convenient to your laundry washing temperature. Select the available options by pressing buttons 3, 4 and 5 • Measure out the detergent. For the quantity of detergent, refer always to what is written on the product packing and ensure that the detergent can be poured in the drawer.
starts operating and the only pilot light corresponding to the running phase stays on. To interrupt a programme which is running, press the button 6 : the corresponding green pilot light starts blinking. To restart the programme from the point at which it was interrupted, press the button 6 again . If an incorrect option is selected, the red pilot light of the button 6 blinks 3 times. Altering an option or a running programme It is possible to change some options before the programme carries them out.
Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only).
Programme - Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment COTONE - LINO QUOTIDIANO 60° - Cold Main wash - Rinses Maximum spin speed at 1000 rpm Maximum load 7 kg Quick wash cycle for white or fast colour cotton (slightly soiled items).
Programme - Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options TENDE 40° - Cold Prewash - Main wash - Rinses Maximum spin speed at 800 rpm Maximum load 2 kg With this programme it is possible to wash curtains with an extra water load. We suggest that you do not put any detergent into the prewash compartment.
Programme - Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options AMMOLLO 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 7 kg Special programme for heavily soiled laundry. The machine performs a soak at 30°C. At the end of this time the machine will stop automatically with water left in the tub.
Programme - Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment O = OFF For cancelling the programme which is running or to switch the machine off . 1) If you select the BREVE option by pressing the button 4 , we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results.
Problem Possible cause/Solution The machine does not empty and/ or does not spin: The drain hose is squashed or kinked (the button 6 red light blinks). • Check the drain hose connection. The drain filter is clogged (the button 6 red light blinks). • Clean the drain filter. An option or a programme that ends with the water still in the tub or a that eliminates all the spinning phases has been selected. • Select the draining or spinning programme. The laundry is not evenly distributed in the drum.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Programme Energy consumption (KWh) Water consumption (litres) Programme duration (Minutes) DELICATI 40° 0.60 63 70 LANA / A MANO 30° 0.25 55 55 1) This programme at 60°C with a load of 7 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
1 2 Open the pump door levering on the groove with a coin (or with the suitable tool, that you can find in the bag containing the instruction booklet, depending on the model). Place a bowl with a small edge close to the pump to collect any spillage. Check carefully whether the pump impeller rotates (it rotates jerkily). If it doesn’t rotate, please contact your Service Centre. Pull out the emergency emptying cap from the pump cover, using pliers.
Cleaning the water inlet filters Important! If the appliance doesn't fill, takes long to fill with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight.
If necessary, check the setting with a spirit level. After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Remove the power supply cable and the hoses from the hose holders on the rear of the appliance.
Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In a sink drain pipe branch . This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated , i.e.
This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). 22 • The machine works more economically if it is fully loaded.
www.electrolux.
