User manual

6. Install the lower pin on the opposite side.
7. Tighten the middle hinge.
8. Install the upper door.
9. Tighten the spacer and tighten the upper pin.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest Authorised Service Centre. The
Authorised Service specialist will carry
out the reversibility of the doors at your
cost.
Installing the appliance
Make sure that the mains cable can
move freely.
1. If necessary cut the adhesive sealing strip and then
apply it to the appliance as shown in figure.
x
x
2. Push the appliance in the direction of the arrows (1)
until the upper gap cover stops against the kitchen
furniture.
3. Push the appliance in the direction of the arrows (2)
against the cupboard on the opposite side of the
hinge.
1
2
4. Make sure that the distance between the appliance
and the cupboard front-edge is 44 mm.
4mm
44mm
The lower hinge cover (in the accessories bag)
makes sure that the distance between the
appliance and the kitchen furniture is correct.
5. Make sure that the clearance between the
appliance and the cupboard is 4 mm.
6. Open the door. Put the lower hinge cover in
position.
7. Attach the appliance to the niche with 4 screws.
I
I
8. Remove the correct part from the hinge cover (E).
Make sure to remove the part DX, in the case of
right hinge, SX in opposite case.
9. Attach the covers (C, D) to the lugs and the hinge
holes.
11