User manual

Water hardness
Water softener
adjustment
German
degrees
(°dH)
French
degrees
(°fH)
mmol/l Clarke
degrees
Manual Electron-
ic
29 - 36 51 - 64 5.1 - 6.4 36 - 45
2
1)
7
23 - 28 40 - 50 4.0 - 5.0 28 - 35
2
1)
6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
2
1)
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 1 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 1 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 1 2
< 4 < 7 < 0.7 < 5
1
2)
1
2)
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener manually and
electronically.
Manual adjustment
1
2
Turn the water hardness
dial to the position 1 or 2.
Electronic adjustment
1. Make sure that the programme marker on the pro-
gramme knob is aligned with the on/off indicator.
2. Press and hold the start button. At the same time
turn the programme knob clockwise until the pro-
gramme marker is aligned with the first programme
on the control panel.
3. Release the start button when the start indicator
and the on/off indicator start to flash.
• The end indicator flashes intermittently. The
number of flashes shows the level of the water
softener, e.g. 5 flashes + pause + 5 flashes =
level 5.
4. To adjust the level of the water softener, press the
start button. Each time you press the start button
you go to the next level.
5. To confirm the setting, turn the programme knob
until the programme marker is aligned with the on/
off indicator.
Filling the salt container
Caution! Water and salt can come out from the
salt container when you fill it. Risk of corrosion.
To prevent it, after you fill the salt container, start a
programme.
1 2
17