User manual

Care and cleaning
Warning! Refer to Safety chapters.
Notes on cleaning
• Clean the front of the appliance with a soft cloth with
warm water and a cleaning agent.
• To clean metal surfaces, use a usual cleaning
agent.
• Clean the appliance interior after each use. Fat
accumulation or other food remains may result in a
fire. The risk is higher for the grill pan.
• Clean stubborn dirt with a special oven cleaner.
• Clean all accessories after each use and let them
dry. Use a soft cloth with warm water and a cleaning
agent.
• If you have nonstick accessories, do not clean them
using aggressive agents, sharp-edged objects or a
dishwasher. It can cause damage to the nonstick
coating.
Stainless steel or aluminium appliances
Clean the oven door with a wet sponge
only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel
with the same precautions.
Removing the shelf supports
To clean the oven, remove the shelf supports.
1
Pull the front of the shelf
support away from the
side wall.
1
2
1
2
Pull the rear end of the
shelf support away from
the side wall and remove
it.
2
Install the shelf supports in the opposite sequence.
Pyrolysis
Caution! Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if you did not
fully close the oven door. In some
models, the display shows "C3" when
this error occurs.
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If there are other appliances
installed in the same cabinet, do not use
them at the same time as the Pyrolysis
function. It can cause damage to the
appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot water, so
that the residues do not burn from the hot air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
4. When flashes, press or to set the
necessary procedure:
Option Description
P1 If the oven is not very
dirty. Time of the pro-
cedure: 1 h.
P2 If you cannot easily
remove the dirt. Time
of the procedure: 1 h
30 min.
After 2 seconds the procedure starts.
You can use the End function to delay the start of the
cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set temperature, the door
locks. The display shows the symbol and the
bars of the heat indicator until the door unlocks.
To stop Pyrolysis before it is completed, turn the
knob for the oven functions to the off position.
6. When Pyrolysis is completed, the display shows
the time of day. The oven door stays locked.
7. When the appliance is cool again, an acoustic
signal sounds and the door unlocks.
Cleaning reminder
To remind you that the Pyrolysis is necessary, PYR
flashes in the display for 10 seconds after each
activation and deactivation of the appliance.
17