User manual

Problem Possible cause Remedy
The oven does not heat up. The fuse is released. Make sure that the fuse is the cause
of the malfunction. If the fuse relea-
ses again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
It takes too long to cook the dishes
or they cook too quickly.
The temperature is too low or too
high.
Adjust the temperature if necessary.
Follow the advice in the user man-
ual.
Steam and condensation settle on
the food and in the cavity of the
oven.
You left the dish in the oven for too
long.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
The display shows "C3". The cleaning function does not op-
erate. You did not fully close the
door, or the door lock is defective.
Fully close the door.
The display shows "F102".
• You did not fully close the door.
• The door lock is defective.
• Fully close the door.
• Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows "F102"
again, contact the Customer
Care Department.
The display shows an error code
that is not in this table.
There is an electrical fault.
• Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
The appliance is activated and does
not heat up. The fan does not oper-
ate. The display shows "Demo".
The demo mode is activated.
1. Deactivate the oven.
2. Press and hold the button .
3. When an acoustic signal
sounds, turn the knob for the
oven functions clockwise to the
first function. "Demo" flashes
in the display.
4. Turn the knob for the oven
functions to the off position.
5. Release the button .
6. Turn the knob for the tempera-
ture clockwise and hold it for
three seconds. The acoustic
signal sounds three times. The
demo mode is deactivated.
20