User manual

1
2
4
3
1 Burner cap
2 Burner crown
3 Ignition candle
4 Thermocouple
Warning! Do not keep control knob pressed for
more than 15 seconds.
If the burner does not light after 15 seconds, release
the control knob, turn it into off position and wait for at
least 1 minute before trying to light the burner again.
If the burner accidentally goes out, turn the con-
trol knob to the off position and wait for at least 1
minute before trying to light it again.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it
off before you remove the pans of the burner.
Glass lids may shatter when heated. Turn off
all burners before shutting the lid.
Hob - Helpful hints and tips
Energy saving
• If possible, always put the lids on the cookware.
Gas
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Electric
• Put cookware on a cooking zone before you start it.
• Stop the cooking zone before the end of the cooking
time to use residual heat.
• The bottom of pans and cooking zone must have the
same dimension.
Warning! Use pots and pans with bottom
applicable to the dimension of burner.
Do not use cooking vessels on the hotplate that overlap
its edges.
Burner Diameters of cookware
Rapid 160 - 260 mm
Semi-rapid 120 - 220 mm
Auxiliary 80 - 160 mm
Use cookware with the bottom as thick and flat as pos-
sible.
Hob - Care and Cleaning
Warning! Switch the appliance off and let it cool
down before you clean it.
Warning! For safety reasons, do not clean the
appliance with steam cleaners or high-pressure
cleaners.
Warning! Do not use abrasive cleaners, steel
wool pads or acids, they can cause damage to
the appliance.
• To clean the enamelled parts, cap and crown, wash
it with warm soapy water.
• Stainless steel parts wash with water, and then dry
with a soft cloth.
• The pan supports are not dishwasher proof; they
must be washed by hand .
• Make sure you position the pan supports correctly
after cleaning.
• To make burners work correctly, make sure that the
arms of the pan supports are in the centre of the
burner.
• Be very careful when you replace the pan sup-
ports to prevent the hob top from damage.
6