User manual

4
INSTALLATION
If this appliance – equipped with magnetic door
seals – replaces an older appliance featuring a
spring lock (mechanical latch) on the door or lid,
please ensure that this lock is made completely
unusable before «throwing out» the old appliance.
This will prevent it from becoming a death-trap for
a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18
° C and +43 ° C (class T);
+18
° C and +38 ° C (class ST); +16 ° C and +32 ° C (class
N); +10
° C and +32 ° C (class SN).
The class of your appliance is shown on its rating plate.
Make sure that there is nothing hindering air
circulation at the back, bottom or top of the appliance.
To achieve the best performance, the top of the
appliance – if set under a wall cabinet – should be at
least 5 mm away from the base of the cabinet (Figure
1 - A). However, the appliance should ideally not be
installed underneath wall cabinets (as shown in Figure
1 - B).
It can be positioned with its sides set tight against
adjacent furniture as long as air is able to circulate
freely behind and above it.
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly level.
Fig. 1
Rear spacers
Fig. 2
In the bag with the
documentation,
there are two
spacers which
must be fitted as
shown in the figure.
Slacken the screws
and insert the
spacer under the
screw head, then
re-tighten the
screws.
A
B
D174
5mm
PR153
Power connection
Before plugging in the appliance to the mains
socket, check that the voltage and frequency
indicated on the appliance’s rating plate are the
same as those provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable.
For operation at different voltages, a suitable
transformer should be used.
The appliance MUST be connected to an efficient
earth or ground tap.
The supply-lead plug in fact incorporates a special
earth or ground contact for this purpose. If by any
chance the sockets of your domestic wiring system
are not earthed, the appliance must be connected to
a separate earth or ground wire by a qualified
electrician, in accordance with existing safety
regulations.
The manufacturer declines to accept any liability if
this accident-prevention procedure is not followed.
This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Replacing the power supply cord
If the power supply cord has to be replaced, take
care when connecting the terminals:
– the
yellow/green wire must be connected to the
terminal marked with the earth symbol ;
– the
brown wire must be connected to the live
terminal, marked with the letter «L»;
– the
blue wire must be connected to the neutral
terminal marked with the letter «N».
Cleaning the appliance’s interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly. Do not use detergents or
abrasive powders as these will damage the finish.