User manual

Problem Possible solution
The appliance makes an
unusual noise.
• Make sure the levelling of the appliance is correct. Refer to "Instal-
lation".
• Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation".
• Add more laundry in the drum. The load may be too small.
The cycle is shorter than
the time displayed.
• The appliance calculates a new time according to the laundry load.
See the "Auto sense function" at daily use chapter.
The cycle is longer than
the time displayed.
• An unbalanced laundry load increases the duration time. This is a
normal behaviour of the appliance.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you
wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
You cannot set an option. • Make sure that you press only the wanted button(s).
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the appliance shows other alarm codes (the indicator of button flashes in red). Deactivate and acti-
vate the appliance. If the problem continues, contact the Authorised Service Centre.
TECHNICAL DATA
Dimension Width/ Height/ Depth/ To-
tal depth
596 mm/ 854 mm/ 607 mm/ 643 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220-230 V
2000 W
10 A
50 Hz
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against
moisture
IPX4
Water supply pressure Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Water supply
1) Cold water
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
PRODUCT INFORMATION SHEET IN REFERENCE TO E.U. REGULATION
1369/2017
Product Information Sheet
19