User manual

Measure out the fabric
conditioner.
Carefully close the deter-
gent drawer.
BLEACH
Alternatively the softener, it is also possible to use a
bleach agent in the compartment with the
programmes for white cottons.
Proceed as follows:
1. Put the bleach in the compartment .
Do not exceed the «MAX» mark in the detergent
dispenser drawer.
2. Run a programme for white cottons.
3. At the end of the programme, run the
programme RINSE. Use softener, if desired.
This helps to eliminate any bleach residues.
Never pour bleach and softener into
the compartment at the same time.
SETTING A PROGRAMME
1. Turn the programme knob to switch the
appliance on and set the programme:
• The indicator of the button flashes.
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message .
Autosense function
At the start of the programme, the display shows
the programme duration for the maximum load
capacity. During the washing phase the programme
duration is automatically calculated and can be
greatly reduced if the laundry load is lower than the
maximum load capacity. When the appliance is
calculating the real programme duration the display
is alternatively showing the " loading " animation
and the max load capacity time duration .The
new time duration is appearing when calculation is
finished. (e.g. Cotton 30° programme , maximum
load capacity 8 kg , the default programme duration
exceeds 2 hours, in case of actual load 2 kg, the
program duration will be reduced to only 1 hour 20
min).
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button .
• The indicator of the button stops to
flash and stays on.
• The programme starts, the door locks, the
indicator is on.
• The programme time decreases with steps
of one minute.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
1. Press the button Partenza posticipata again
and again until the display shows the delay you
want to set. The delay start indicator comes on.
2. Press the button Avvio/Pausa :
• The door is locked and the indicator is
on.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Partenza posticipata option
before you press the button Avvio/
Pausa . After pressing the button
Avvio/Pausa you can only cancel
the Avvio/Pausa option.
To cancel the Partenza posticipata option:
a. Press the button Avvio/Pausa to set
the appliance to pause. The indicator of
button flashes.
b. Press the button Partenza posticipata
until the display shows .
Press the Avvio/Pausa button again to
start the programme immediately.
13