Installation Guide

FINIAL LENGTH
Pineapple 1
3
/
8
"
Round
3
/
4
"
Urn 1
1
/
4
"
SPECIFICATIONS
Zoroufy Stair Rods slide
into each bracket
approximately 1/2". Finials
attach to the bracket not
the rod.
1. The carpet runner must be installed using
another method of installation. Zoroufy
stair rods are for decorative use only.
2. Attach finials to the brackets using small
screws provided in finials.
3. Locate desired position of the brackets by
inserting the rod into the brackets and
laying on the stairs. Positioning both the
left and right bracket an equal distance
from the side edges of the runner is the
most preferable position.
4. For each step, install one bracket onto
stairs using screws provided or other
anchors suitable for stair material.
Drilling a pilot hole first is recommended.
Insert the rod into the installed bracket
and place remaining bracket on the other
end to confirm exact position of the
bracket on the other side.
5. Install remaining bracket using the same
method as above.
Finial
Rod
Installation
Screws
Finial
Screw
Bracket
1.38''
.5''
1.38''
0.45''
0.45''
Finial measurements
vary by style. Please
see chart at left.
S
elect
TM
COLLECTION
SELECT™ COLLECTION STAIR ROD SET INSTALLATION INSTRUCTIONS
ALWAYS USE A NON-SLIP PAD AND/OR ANOTHER
MEANS OF INSTALLATION. STAIR RODS ALONE ARE
NOT A FORM OF CARPET INSTALLATION.
ALL PARTS ARE LACQUER COATED TO RESIST
TARNISHING. DO NOT USE BRASS CLEANER OR
OTHER ABRASIVES. TO CLEAN, SIMPLY WIPE WITH A
SOFT DRY CLOTH.
PERIODICALLY CHECK AND TIGHTEN ALL SCREWS
AND HARDWARE.
© Zoroufy 2005
Illustrations in this book cannot be reproduced in part or
in whole without the written consent of Zoroufy Stair Rods.
Rod Gauge: .031"