User's Manual

Web Control User Interface Setting
21
The range of bit rate is 100 kbps~ 20,000 kbps. The default value is 2,000 kbps. 2,000 kbps is the best
economic setting for the trade-off between image quality and bit rate
NOTE:
Once the video goes live, the real bitrate of video streaming is shown on the top-right of LCD. If the
average bitrate on LCD is smaller than your target setting above. That means the upload bandwidth is
not enough. In this situation, target bitrate can be lowered to improve the performance. The resolution
can also be lowered if bitrate is low.
I Frame Interval
The range of I frame interval is 5~200. The default value is 40.
Bitrate Control
The “Bit Rate Control” can be chosen as “CBR” (Constant Bitrate) or “VBR” (Variable Bitrate).
Resolution
The Resolution choose from:
 1080P (FHD)
 960 (Portrait)
 720P (HD)
 576P (PAL)
 360P (Standard)
The default value is 1080P (FHD) .
3.7 RTMP Param
After clicking the “RTMP Param” option on the left column of the web control UI. User can configure
streaming parameter that include “Enable”, “Connection Status”, “Model”, “Streaming Network” and
“RTMP Address” on the RTMP Parameter option control page. At first please switch “Enable” button is
“ON”. Then the user should select Streaming “Model”.
1． If the “Model” is selected as “Single”, the user can select one of Auto, Lan, Built-in WIFI, as the “Stream
Network”.
2． If the “Model” is selected as “Bonding”, the device will bond multiple connected networks as stream
network. Furthermore, the encoder supports up to 9 RTMP Address streaming simultaneously in this
model.
Last, please fill in “RTMP Address” and click “Confirm” button to apply the setting.