Specifications
12
START-UP INSTRUCTIONS (CS6200-EX)
DownDown
AuxAux
LightLight
Jets 1Jets 1
UpUp
TMTM
Engineered With Visual IlluminationEngineered With Visual Illumination
Visual Diagnostic SystemVisual Diagnostic System
Pump 1
Aux
Light
Temp Set Key
Adjust Up & Down
Default System Operation: When power is applied, or there is a temporary loss of power,
the system will initiate its default programming. The filter cycle will begin24-hours after
the system has been powered up. The filtration cycle will be active for 1-hour and will
repeat every 12-hours. The temperature will be maintained at 95
o
F. (Default setting can
change) w/out notice
Pump 1 Key (Jets 1): Press this key once to turn Pump 1 onto Low speed, press this key
a second time to turn Pump 1 onto High speed, a third press will turn the pump off. A
built-in timer will shut the pump off after 20 minutes of operation unless done so
manually. The Pump 1 indicator will illuminate while the pump is running. If the filter
cycle indicator is illuminated, a filtration cycle has begun and you will not be able to turn
the pump off.
Temperature Set Keys: Press the Temperature Set Key Up to increase the desired
temperature. Release and press again to lower the temperature. The temperature can be
adjusted in 1
o
F increments from 59
o
F to 104
o
F (5
o
C to 40
o
C). The new setting will
remain on the display for 5 seconds as a confirmation. During this time the Temperature
Program indicator will illuminate to let you know this is the desired and not the actual
temperature. After 5 seconds the display will return to the current temperature reading.
When the temperature drops to 1
o
F below the set temperature, the heater will be turned
on until the temperature is 1
o
F above the set temperature. The Heater On indicator will
illuminate while the heater is on and flash when there is a call for heat and the heater has
not yet been activated.
Light Key: Press this key to turn the Light on and off. The light will automatically shut
off after 2 hours.
Blower Key: (If equipped) Press blower key to turn blower on. A second press will turn
blower off. Blower will run for 20 minutes then shut down.