Specifications

SPA CARE AND MAINTENANCE
Vacation Care Of Spa
Following these instructions to ensure that the water quality of your spa is maintained:
For Short Periods (3 to 5 days)
Adjust the pH
Sanitize the water
Lock cover for safety
For Long Periods (5 to 14 days)
0
Set temperature to its lowest level approximate water temperature of 80 F.
Adjust the pH
Sanitize the water
Lock cover for safety
Return Procedures
Sanitize the water following shock procedures
Return water temperature to original setting
Insure chlorine level had dropped below 5.0 ppm
NOTE: If you plan on not using your spa for periods exceeding 14 days, you may ask a family member or neighbor to assist with
your spa maintenance, and if not available you will need to drain or winterize spa.
Winterizing Your Spa
During the cold weather you may not wish to use your spa outside. In this case you may move it to a heated area, or leave it until the
weather warms up.
WARNING: Allowing your spa water to freeze will cause severe damage to the spa shell, equipment, and plumbing and WILL
VOID WARRANTY.
The following steps should protect your spa from freezing:
!
Disconnect the spa from the power supply.
!
Remove the screws holding your spa excess panel door.
!
Open the valve and the spa will drain by gravity flow.
!
Remove the filter cartridge, then clean and store in a dry place.
!
Attach a wet/dry shop vac (capable of blowing air as well as vacuuming) into the filter housing.
!
Turn blower on and allow it to blow out any water remaining in the plumbing lines. (Should take no more than 5
minutes).
!
Reinstall the filter housing.
!
Use the shop vac to remove water inside spa blown through jets.
!
Use a shop vac and clean towel and remove any remaining water from bottom of spa until dry.
!
Leave the drain open.
!
Close the spa cover and fasten with tie down safety loks.
17