User's Manual


4. Follow the instructions on the
connector drawing to process the
cable.
5. Insert the positive and negative wires to the
correct holes of the power connector (The blue wire
is negative and the black wire is positive).
6. Insert the shielding wire of the cable to the
shielding wire hole.



7. Tighten the four screws for positive
and negative wires of the power cable.
You should tighten the two screws that
are close to the connector head first,
and then the other two screws.
8. Tighten the screw for the shielding wire.
Note: After the five screws are all tightened, the
cable should
not be loosened under a pulling force of 2 Kg.
