User manual

operating device can be below the
maximum value because the device
is designed to use only the power
required to reach the network. That
amount changes depending on a
number of factors such as how close
you are to a network base station.
Use of device accessories and
enhancements may result in dierent
SAR values. SAR values may vary
depending on national reporting and
testing requirements and the network
band. Additional SAR information may
be provided under product
information at.
Your mobile device is also designed
to meet the requirements for
exposure to radio waves established
by the Federal Communications
Commission (USA) and Industry
Canada. These requirements set a
SAR limit of 1.6 W/kg averaged over
one gram of tissue. The highest SAR
value reported under this standard
during product certification for use at
the ear is 0.833W/Kg and when
properly worn on the body is
0.304W/Kg.
SAFETY INFORMATION FOR FIXED
WIRELESS TERMINALS
POTENTIALLY EXPLOSIVE
ATMOSPHERES
Turn your phone OFF when in any
area with a potentially explosive
atmosphere and obey all signs and
instructions. Sparks in such areas
could cause an explosion or fire
resulting in bodily injury or even
death.
INTERFERENCE TO MEDICAL
DIVICES
Certain electronic equipment may be
shielded against RF signal from you
wireless phone. (pacemakers,
Hearing Aids, and so on) Turn your
phone OFF in health c are facilities
when any regulations posted in these
areas instruct you to do so. RF signals
may aect improperly installed or
inadequately shielded electronic
system in motor vehicles.
58
Additional safety information
EXPOSURE TO RF ENERGY
Use only the supplied or an
approved replacement antenna.
Do not touch the antenna
unnecessarily when the phone is in
use. Do not move the antenna close
to, or couching any exposed part of
the body when making a call.
BODY-WORN OPERATION
This device was tested for typical
body-worn operations with the back
of the phone kept 2.0 cm from the
body. To maintain compliance with
FCC RF exposure requirements, use
only belt-clips, holsters or similar
accessories that maintain 2.0 cm
separation distance between the
user’s body and the back of the
phone, including the antenna. The
use of belt-clips, holsters and similar
accessories should not contain
metallic components in its assembly.
The use of accessories that do not
satisfy these requirements may not
comply with FCC RF exposure
requirements, and should be
avoided.
For more information about RF
exposure, please visit the FCC
website at www.fcc.gov.
FCC compliance information
This device complies with Part 15 of
FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received.
Including interference that may cause
undesired operation.
U.S.A.
U.S.FEDERAL COMMUNICATIONS
COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT
INFORMATION TO THE USER
note This equipment has been tested
and found to comply with the limits
for a Class B digital device pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide
Additional safety information
59