E1320 Wi-Fi6 Wireless Router User Manual
Step 1-Install the Device 1
Step 2-Add the Router Download and install ZLife Lite. For iOS, download ZLife Lite on App Store. For Android, download it on Google Play. Tap Add device.
Tap Wi-Fi Router. Connect the WAN port of the router to the broadband port. Tap Next.
Scan the QR code found at the bottom of the router. If no QR code is present, enter your wireless account and password. NOTE: If the operating system of your mobile phone is Android, you must connect to Wi-Fi manually after scanning the QR code. If you do not want to enter the password manually, tap copy the password. This operation arises from Android rather than ZLife Lite because of Android security requirements.
After the router is added successfully, the Configure network screen is displayed. Tap Bind immediately. After the router is added successfully, the indicator is green and steady. LED indicator/WPS NOTE: To perform more advanced configurations, go to the web page for router management. For the login address and the default username and password, see the label at the bottom of the router.
Step 3- Set Up a Mesh Network NOTE: Step 3 is required only if you want to deploy multiple E1320 routers. Method 1: Use ZLife Lite app for connection 1. Make sure the router you have just configured is connected to the Internet. 2. After the new router is powered on, follow the instructions given by the app. 3. After the new router is connected to the existing router, the LED of the new router will turn solid blue. Method 2: Use WPS key for connection 1.
Troubleshooting The Power indicator on the front panel is off after the power button is pressed. Power switch does not turn on. The power adapter is not correctly connected to the device. Be sure to use the power adapter supplied with the device. Unable to connect to the network. Check that the Ethernet cable is correctly connected to the WAN interface and the Ethernet cable is correctly connected to the LAN interface.
FAQ How to use the Repeater mode? Only the Repeater mode(used to extend the Wi-Fi signals of the existing router or optical modem) needs to be set on the Web interface. Other modes can be self-adaptive without this operation. 1. After the device is powered on, use a network cable to connect the network interface of the computer to the LAN interface of the device. 2. In the address bar of the browser, enter 192.168.50.1, and press Enter to open the Web page. 3.
Use wireless mode to extend Wi-Fi: The WPS key can be used for pairing. lf the existing router or optical modem does not support the WPS key mode, perform the following operations: On the main page of the E1320, select Local Network> WLAN >WLAN Discovery > WLAN Discovery to open the WLAN Discovery page. Click Scan wireless network to scan the Wi-Fi signal, select the wireless network you want to connect to, and enter the password to connect to the wireless network. 7. After the device is networked.
SJ-20220322181146-002 2022-10-09(R1.
