Operation Manual

11
You can find the default SSID on the label of your device.
4. Enter the password, and then click OK.
NOTE:
You may need to enter the password for the Wi-Fi connection. You can view the label on your device to get
the default password.
5. Wait until the client is connected to your device successfully.
Troubleshooting
Voice Related Problems
Symptoms
Possible Problems/ Solutions
No dial tone
• Please wait for 1~2 minutes after the device is
turned on.
• If signal LED light is blinking, you have no good
radio reception. Change the location of the device.
There is a prompt/ phone alert/ announcement as soon as I
lift the phone off the hook.
Make sure your (U)SIM card is inserted correctly and
the PIN number has been entered. If the PIN number has
been entered incorrectly then you will need to enter the
PUK code when prompted.
The line is noisy/ distorted when I lift the phone off the
hook.
• Remove any electrical appliance which is too close
to the phone or your device.
• The cable or phone set might be faulty. Please check
the connection.
I hear a rapid engaged tone as soon as I lift the phone off
the hook.
Put the phone on the hook and try again. If you are
connected to the internet using the 2G (GSM) network,
please disconnect this first.
After dialing the last digit I hear nothing /silence.
When you have finished dialing you can press the # key
or wait 4~8 seconds to connect the call.
Internet Related Problems
Symptoms
Possible Problems/ Solutions
I cannot access the Internet at all.
• Please check your configuration settings.