User manual

Installing a microSDHC™ card (not included)
The microSDHC card can be installed and removed while the phone is
powered on. Unmount the microSDHC card before removing or replacing it.
1. Remove the back cover.
2. Hold your microSDHC card with the metal contacts
facing down and slide it into the card slot.
Note: Some applications may require a microSDHC card
to work normally or may store certain data on it. Therefore,
it is recommended that you keep a microSDHC card
installed and not remove or replace it randomly.
3. Press the back cover gently back into place until you hear a click.
Charging the battery
Your phone’s battery should have enough power for the phone to turn on,
nd a signal, and make a few calls. You should fully charge the battery as
soon as possible.
If the battery is low, there will be a pop-up message on the screen. As you
charge your phone, the screen will tell you the exact battery level each time
you wake up your phone.
If the battery is extremely low, you may be unable
to power on the phone even when it is being charged.
In this case, try again after charging the phone for at
least 10 minutes. Contact customer service if you still
cannot power on the phone after prolonged charging.
1. Insert the charger’s connector into the charging port.
Be sure to insert the connector in the correct
orientation. Do not force the connector into the port.
9GETTING STARTED
8 GETTING STARTED
2. Plug the charger into a standard AC wall outlet.
3. When the battery is fully charged, unplug the charger and disconnect it
from the phone.
Warning! Use only ZTE-approved chargers and cables. The use of unapproved
accessories could damage your phone or cause the battery to explode.
Caution: Do not change the built-in rechargeable battery in your phone
by yourself. The battery can only be changed by ZTE or ZTE authorized
service provider.
Extending the battery life
Active applications, screen brightness levels, Bluetooth and Wi-Fi usage, and
GPS functionality can drain your battery. You can follow the helpful tips below
to conserve your battery power:
Reduce the screen backlight time.
Lower the screen brightness.
Turn auto-sync, Wi-Fi, and Bluetooth off when not in use.
Disable the GPS function when not in use. Most applications using this
function will periodically query the GPS satellites for your current location;
each query drains your battery.
Powering your phone on/off
Make sure the micro-SIM card is in your phone and the battery is charged.
Press and hold the Power key to power on your phone.
To power it off, press and hold the Power key to open the options menu.
Tap Power off.