User manual

42
43
Connecting to a WPS network
Wi-Fi Protected Setup (WPS) is a feature that makes it easy to add your phone
to access points that support WPS.
You can use one of the following methods to connect your phone to a
wireless network using WPS.
Method one: WPS button (Recommended)
1. Press the Home key > > Settings > Wi-Fi.
2. Slide the switch to the On position.
3. Tap > Advanced > WPS Push Button.
4. Press the WPS button on the access point, and it will recognize your phone
and add it to the network.
Method two: PIN
1. Press the Home key > > Settings > Wi-Fi.
2. Slide the switch to the On position.
3. Tap > Advanced > WPS Pin Entry.
4. The WPS PIN displays on the screen. Enter the PIN into the access point’s
setup page.
After entering the PIN, your phone automatically nds the access point and
congures the connection.
Note: For detailed information about the WPS feature of the access point,
please refer to its documentation.
Adjusting advanced Wi-Fi settings
1. Press the Home key > > Settings > Wi-Fi.
2. Tap to adjust the following settings:
• Saved networks: View a list of saved networks.
• Network notication: Get notications in the status bar when Wi-Fi is on
and an open network is available.
• Keep Wi-Fi on during sleep: Set whether to keep Wi-Fi on in Sleep mode.
• MAC address: Check the MAC address.
• IP address: Check the phone’s IP address.
3. From the main Wi-Fi menu, tap > Advanced to adjust the following settings:
• Install certicates: Install certicates needed for connecting to certain
Wi-Fi networks.
• Wi-Fi Direct: Use the Wi-Fi Direct feature. (See Using Wi-Fi Direct below.)
• WPS Push Button: Connect to a WPS network via the push button method.
• WPS Pin Entry: Connect to a WPS network via the phone PIN method.
Using Wi-Fi Direct
Wi-Fi Direct allows Wi-Fi devices to connect to each other without the need for
wireless access points (hotspots). Your phone supports Wi-Fi Direct, but you
may need to install third-party applications to share data through Wi-Fi Direct.
Note: Activating this feature will disconnect your current Wi-Fi network
connection.
Connecting to another device via Wi-Fi Direct
1. Press the Home key > > Settings > Wi-Fi.
2. If Wi-Fi is off, slide the switch to the On position.
3. Tap > Advanced > Wi-Fi Direct. Your phone will search for other devices
enabled with Wi-Fi Direct connections.
CONNECTING TO NETWORKS AND DEVICES
CONNECTING TO NETWORKS AND DEVICES