User Manual

134 135
For this device, the highest reported SAR value for usage against the head is
1.16 W/kg, for usage near the body is 1.09 W/kg.
While there may be differences between the SAR levels of various phones
and at various positions, they all meet the government requirements.
SAR compliance for body-worn operation is based on a separation distance
of 0.4 inches (10 mm) between the unit and the human body. Carry this device
at least 0.4 inches (10 mm) away from your body to ensure RF exposure level
compliant or lower to the reported level. To support body-worn operation,
choose belt clips or holsters, which do not contain metallic components, to
maintain a separation of 0.4 inches (10 mm) between this device and your
body.
RF exposure compliance with any body-worn accessory that contains metal
was not tested and certified, and use such body-worn accessory should be
avoided.
FCC REGULATIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
FOR YOUR SAFETY
FCC RF EXPOSURE INFORMATION (SAR)
This phone is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest certified
power level in all tested frequency bands, and placed in positions that
simulate RF exposure in usage against the head with no separation, and
near the body with the separation of 0.4 inches (10 mm). Although the SAR is
determined at the highest certified power level, the actual SAR level of the
device while operating can be well below the maximum value. This is because
the phone is designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output.
The exposure standard for wireless devices employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC
is 1.6 W/kg.
This device is complied with SAR for general population/uncontrolled
exposure limits in ANSI/IEEE C95.1-1992 and had been tested in accordance
with the measurement methods and procedures specified in IEEE1528.
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
after searching on FCC ID: SRQ-Z5156CC.
FOR YOUR SAFETY