User's Manual
Table Of Contents
- Legal Information
- 1 About This Document
- 2 Product Overview
- 3 Interfaces
- 3.1 Definition of PINs
- 3.2 Working Condition
- 3.3 Feature of Interface Power Level
- 3.4 Power Interface
- 3.5 (U)SIM Card Interface
- 3.6 SD Card Interface
- 3.7 USB2.0 Interface
- 3.8 Serial Interface
- 3.9 JTAG (Joint Test Action Group) Interface
- 3.10 Power-on/Power-off & Reset Signal
- 3.11 Interactive Application Interface
- 3.12 LED Indicator Interface
- 4 Electric Feature
- 5 Technical Index of Radio Frequency
- 6 Related Test & Testing Standard
- 7 Design Guide
- 7.1 General Design Rule & Requirement
- 7.2 Power Supply Circuit Design
- 7.3 RF Circuit Design
- 7.4 Suggestions for EMC & ESD Design
- 7.5 Suggestions for PCB Wielding Panel Design
- 7.6 Suggestions for Heat-dissipation Design
- 7.7 Recommended Product Upgrading Plan
- 8 Manufacturing Guide
- 9 FCC Regulations:
Hardware Development Guide of Module Product
All Rights reserved, No Spreading abroad without Permission of ZTEWelink 35
5 Technical Index of Radio Frequency
5.1 Technical Index of Radio Frequency under
UMTS Mode
5.1.1 UMTS (WCDMA)
The RF index should be tested strictly in accordance with the related testing
specifications of 3GPP. The RF indexes of UMTS2100/1900/850 should satisfy the
requirements of 3GPP TS 34.121 protocol.
5.2 Technical Index of Radio Frequency under
GPRS/GSM/EDGE Mode
The RF indexes of GSM/GPRS/EDGE850/900/1800/1900 should satisfy the
requirements of 3GPP TS 05.05 protocol.
5.3 Technical Parameters of Antenna Testing
Console
ZM5202 supports the AGPS function, so the system equipment needs to add the
AGPS antennal. The design of AGPS antenna is consistent with that of the main
antenna, and its efficiency index can be 3dB lower. The separation degree between
the main antenna and the diversity antenna is required to be greater than 12dB. The
antenna index is divided into the sourceless index and s ourced index. The
sourceless index includes S11, efficiency, gains, orientation diagram and polarity,
which can be used as the parameter measuring the performance of the antenna
itself. The sourced index is also called the OTA index, including TRP (all-round
radiation power), TIS (all-round receiving sensitivity), radiation orientation diagram,
which is an important index measuring the radiation performance of the whole set
(including the antenna, module, circuit main board).