User's Manual

Hardware Development Guide of Module Product
All Rights reserved, No Spreading abroad without Permission of ZTEWelink 38
错误！未找到
用源。
ZM8620_V2
41
[-100]
[-97]
[-95.2]
[-94]
TDD
--
Note 1: The transmitter shall be set to maximum output power level as defined in clause 6.2.5 in the protocol
of 3GPP TS 36.101
Note 2: Reference measurement channel is specified A.3.2 with one sided dynamic OCNG Pattern OP.1
FDD/TDD as described in Annex A.5.1.1/A.5.2.1 in the protocol of 3GPP TS 36.101
Note 3: The signal power is specified per port
Note 4: For the UE which supports both Band 3 and Band 9 the reference sensitivity level of Band 3 + 0.5
dB is applicable for band 9
Note 5: For the UE which supports both Band 11 and Band 21 the reference sensitivity level is FFS.
7.3.3 Spurious Specification
Spurious emission meets 3GPP TS 36.101 protocol requirement.
The receiver spurious emission power refers to the spurious power generated or amplified by the module,
which is tested from the antenna connector.
The spurious emission shall meet the requirement of Table 7-9 and Table 7-10:
Table 7–9 General Requirement of Receiver Spurious Emission
Frequency range
Maximum level
Measurement bandwidth
9 kHz

f < 150 kHz
-36 dBm
1 kHz
150 kHz

f < 30 MHz
-36 dBm
10 kHz
30 MHz

f < 1000
MHz
-36 dBm
100 kHz
1 GHz

f < 12.75 GHz
-30 dBm
1 MHz
Table 7–10 UE Co-existence Spurious Emission Requirement
E-UTRA
Band
Spurious emission
Protected band
Frequency range
(MHz)
Level
(dBm)
Bandwidth
(MHz)
Comment
1
E-UTRA Band 1, 3, 7, 8, 9, 11,
34, 38, 40
FDL_low - FDL_high
-50
1
Frequency range
860-895
-50
1
Frequency range
1884.5-1919.6
-41
0.3
Note
6
,Note
7
1884.5-1915.7
Note
6
, Note
8
E-UTRA band 33
1900-1920
-50
1
Note
3
E-UTRA band 39
1880-1920
-50
1
Note
3
2
E-UTRA Band 2, 4, 5, 10, 12,
13, 14, 17
FDL_low- FDL_high
-50
1