User's Manual

Hardware Development Guide of Module Product
All Rights reserved, No Spreading abroad without Permission of ZTEWelink 40
错误！未找到
用源。
ZM8620_V2
33
E-UTRA Band 1, 3, 8, 34,
38, 39, 40
FDL_low- FDL_high
-50
1
Note
5
34
E-UTRA Band 1, 3, 7, 8, 9,
11, 33, 38,39, 40
FDL_low- FDL_high
-50
1
Note
5
Frequency range
860-895
-50
1
Frequency range
1884.5-1919.6
-41
0.3
Note
7
1884.5-1915.7
Note
8
35
36
37
38
E-UTRA Band 1,3, 33, 34
FDL_low- FDL_high
-50
1
39
E-UTRA Band 34, 40
FDL_low- FDL_high
-50
1
40
E-UTRA Band 1, 3, 33, 34, 39
FDL_low- FDL_high
-50
1
Note
1
FDL_low and FDL_high refer to each E-UTRA frequency band specified in Table 5.5-1 in the protocol
of 3GPP TS 36.101
2
As exceptions, measurements with a level up to the applicable requirements defined in Table 7-9 are
permitted for each assigned E-UTRA carrier used in the measurement due to 2nd or 3rd harmonic
spurious emissions. An exception is allowed if there is at least one individual RE within the
transmission bandwidth (see Figure 5.6-1 in the protocol of 3GPP TS 36.101) for which the 2nd or 3rd
harmonic, i.e. the frequency equal to two or three times the frequency of that RE, is within the
measurement bandwidth.
3
To meet these requirements some restriction will be needed for either the working band or protected
band
4
Requirements are specified in terms of E-UTRA sub-bands
5
For non synchronized TDD operation to meet these requirements some restriction will be needed for
either the working band or protected band
6
Applicable when NS_05 in section 6.6.3.3.1 in the protocol of 3GPP TS 36.101 is signaled by the
network.
7
Applicable when co-existence with PHS system working in. 1884.5-1919.6MHz.
8
Applicable when co-existence with PHS system working in 1884.5-1915.7MHz.