User's Manual

12.NOTICE
Note1 ： This device complies with Part 15 of the FCC Rules ， Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note2: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Note3: For EUT which intended use is at least 20 cm between human body and antenna.
Note4: Label of The End Product
The final end product must be labeled in a visible are with the following “ Contains TX
FCC ID:SRQ-ZM8620 ” .The FCC part 15.19 statement below has to also be available on
the label:This device complies with Part 15 of FCC rules.Operation is subject to the foll
owing two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause u
ndesired operation. To comply with FCC regulations limiting both maximum RF output
power and human exposure to RF radiation.
A user manual with the end product must clearly indicate the operating requirements a
nd conditions that must be observed to ensure compliance with current FCC RF expos
ure guidelines. The end product with an Module may also need to pass the FCC Part 1
5 unintentional emission testing requirements and be properly authorized per FCC Part
15. Note:If this module is intended for use in a portable device,you are responsible for
separate approval to satify the SAR requirements of FCC Part 2.1093.