Legal Information Copyright © 2009 ZTE CORPORATION All Rights Reserved Your mobile phone is made by ZTE CORPORATION. No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of ZTE CORPORATION. Trademarks ZTE and the ZTE logos are trademarks of ZTE CORPORATION. Notice The information in this manual is subject to change without notice.
Security To protect your mobile phone from illegal use, take the security measures as follows: ¾ Set PIN codes of the SIM card. ¾ Set handset lock code. ¾ Set call restrictions. Safety Precautions This section includes some important information on safe and efficient operation. Please read this information before using the phone. Operational Precautions Please use your phone properly. When making or receiving a call, please hold your phone as holding a wireline telephone.
Keep the phone out of the reach of small children. The phone may cause injury if used as a toy. Changes or modifications not expressly approved by the ZTE could void the user’s authority to operate the equipment. Precautions While Driving Please pay attention to the traffic safety. Check the laws and regulations on the use of your phone in the area where you drive. Always obey them. Use hands-free function of the phone, if available.
on the use of mobile phone. Switch off your phone if required. Mobile Phone Please use original accessories or accessories approved by the phone manufacturer. Using any unauthorized accessories may affect your mobile phone’s performance, damage your phone or even cause danger to your body and violate related local regulations about telecom terminals. Turn off your phone before you clean it. Use a damp or anti-static cloth to clean the phone.
Do not attempt to disassemble the mobile phone or battery. Do not store the phone with flammable or explosive articles. Do not charge the mobile phone without battery. Precautions for Potentially Explosive Atmospheres Switch off your phone prior to entering any area with potentially explosive atmospheres, such as fueling areas, fuel or chemical transfer or storage facilities. Do not remove, install, or charge batteries in such areas.
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.
system shouldn’t be affected by wireless transmission. If you do meet problems above, please contact your automobile provider. Do not place your phone in the area over an airbag or in the airbag deployment area. Airbags inflate with great force. If a phone is placed in the airbag deployment area and the airbag inflates, the phone may be propelled with great force and cause serious injury to occupants of the vehicle.
of the battery. Please store the battery in a cool dry place if you don’t use it for a long period. The battery can be recharged for hundreds of times, but it will eventually wear out. When the operating time (talk time and standby time) is noticeably shorter than normal, it is time to replace it with a new one. Please stop using the charger and battery when they are damaged or show evidence of aging.
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
handset function updating, please refer to the follow-up public information from ZTE CORPORATION.
Key Functions Function Description Left soft key Perform the function indicated at the left bottom of the screen. Right soft key Perform the function indicated at the right bottom of the screen. Centre key Confirm actions and make selections. 4-Way Navigation Key These keys (UP, DOWN, LEFT and RIGHT) allow for navigation through menu options and quick accessing to some function menus. You can customize the fastkey settings of 4-Way Navigation Key in standby mode.
Interface icons Icon Description Signal strength Headset Vibration New message Icon Description Keypad locked Silent mode Alarm clock set Battery status Battery The lithium ion battery of the mobile phone can be immediately used after unpacking. A new battery performs best after three complete charge/discharge cycles. Installing the battery 1. Insert the battery by aligning the gold-colored contacts with the contacts in the battery slot. 2.
Removing the battery 1. Make sure that your mobile phone is switched off. 2. Remove the battery cover. 3. Pull the battery up and remove it from the mobile phone. Open the cover Pull up the battery from here How to insert the SIM card You want a mobile phone that is sophisticated yet easy to use and here it is in your hands! Naturally you are eager to start using it, but first you need to insert the SIM card.
Insert the SIM card Pull out the SIM card What is a SIM card? Every mobile phone has a SIM card (Subscriber Identity Module). This is a micro-chip that holds your personal information such as names and phone numbers. Your phone won’t work without it. If you already have contacts on your SIM card, they can be transferred in most cases. How to charge the battery Your phone is powered by a rechargeable battery.
charge the battery when the phone is switched on, the battery indicator appears with a lightning strike. • When the battery is fully charged, disconnect the charger. Insert Power on/ off your phone Make sure that your SIM card is in your mobile phone and that the battery is charged. Please hold End key to power on/off the phone. The phone will automatically search for the network. Writing text • Change input mode: Press # key to change the input mode (input modes: Eng, *Abc, abc, ABC and 123).
a Navigation key moves the cursor. Predictive text input is based on a built-in dictionary. • Input Digits: In 123 mode, press digit key once to key in a digit. In Eng mode, press the digit key, and select the number by pressing a Navigation key. In *Abc/abc/ABC mode, constantly press the digit key until the number appears. • Input Symbol: Press * key to enter a symbol. In *Abc/abc/ABC mode, constantly press 1 key till the required symbol (common symbols) appears.
• Select to save the number to SIM card or Phone, and then enter the contact’s phone number. • Press Left soft key [OK] or Centre key, then enter a name and confirm by clicking Left soft key [OK] or Centre key again. • You can also save a number right after you’ve made or received a phone call or a text message from someone who is not yet in your contact list. • To delete someone from your contact list, first select the name, then press Left soft key [Options] and choose Delete.
1. Go to Menu→Messaging→New message. 2. Write your message. For more information on writing, see section ‘Writing text’. 3. Press Left soft key [Options] and select Send to one to send the message to one person. To send to more than one person, select Send to contacts and select the names from the contact list. Select Send and save to send the message and save it to Sent folder. Select Save as draft to save it to Draftbox. 4. Enter the recipient’s phone number or select from Contacts.
screen’s contrast and brightness. • Clock settings: Set date and time, and date format. • Security settings: Security features protect you from illegal use of your phone and SIM card. Note: You need to input the handset lock code to enter the security settings interface. The default lock code is 1234. How to set your alarm • Set alarm: Select Set alarm submenu, you can set the corresponding features of the alarm according to instructions: alarm type (if required), date, time, and ringtone.
• You can set the features of WAP browser. • You can check the previously viewed web addresses and GPRS information. *FM Radio With the radio, you can search for radio channels, listen to them, and save them on your device. Note that the quality of the radio broadcast depends on the coverage of the radio station in that particular area. The wired headset works as an antenna, so always connect the headset when using the radio.