User Manual

ManualsBrandsZTE ManualsCamera & PhotoWIRELESS HD IP CAMERA

Table Of Contents

ZTE HS320 Wireless HD IP Camera

User’s Guide

1 Interfaces

Interface Function

MicroSD slot Insert a TF card into the slot to store local videos.

MicroUSBpower

interface

Connect a power adapter or power bank to the interface.

Mode button Switch between function modes. For details, please refer to the

instructions given by the app.

Reset button Press and hold the button until the LED turns red to restore the factory

settings.

LED

Off The camera is not powered on.

Red Solid: The camera is starting up.

Summary of content (4 pages)

PAGE 1
ZTE HS320 Wireless HD IP Camera User’s Guide 1 Interfaces Interface Function MicroSD slot Insert a TF card into the slot to store local videos. MicroUSBpower Connect a power adapter or power bank to the interface. interface Mode button Switch between function modes. For details, please refer to the instructions given by the app. Reset button Press and hold the button until the LED turns red to restore the factory settings. LED Off The camera is not powered on.
PAGE 2
Flashing: The camera is being upgraded to the latest version. Blue Blue/Green Slow flashing: The camera is awaiting network configuration. Fast flashing: The camera is having its WLAN configured. Flashing alternately in blue and green: The camera is obtaining its IP address. Flashing: The camera has obtained its IP address and is attempting to Green connect to the server. Solid: The camera has been connected to the server and is operating normally.
PAGE 3
4. Installing the HomeCare App  Use your smartphone to scan the QR code below. Then download and install the HomeCare app. Tips: You can also visit http://www.ztehome.com.cn/homecareapp from your smartphone to download the app.  Register on the app as a new user. 5 Adding the Camera  Wait until the LED starts to slowly flash in blue. If the LED does not start to slowly flash in blue, restore the factory settings of the camera by pressing and holding the Reset button until the LED turns red.
PAGE 4
7 FCC Statement FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.