Contents NFC Hardware 1.1 Basic Spec 1.2 Appearance and connector NFC Software 2.1 How to test/verify PNFC20 on 2.
1 NFC Hardware 1.1 Basic Spec. ISOMERIC 14443 Type A/B, read mode, 848 bps TSO/IEC 15693 Mi fare Felicitated UID) Frequency: 13,56 MHz Interface: USB 2.0 Power supply: USB Bus Reading distance: up to 30mm 1.2 Appearance and connector [ 1.2.15crew Hole: Used to fix the module and host 1.2.2POGO PIN: Connect to the host 1.2.
2 Software preregistration before installation 2.1.1.1 Please prepare below 4 items 2.1.1.2 PC:Windows 7 Above 2.1.1.3 2.1.1.4 NFC Reader Module Service 2.1.1.5 NFCReaderDemo.apk 2.2 Installation 2.2.1Pease use below adb commands to install “NFC Reader Module Service into EXPLAIN, and also refer to below explanation...
2.2.2 After you've finished above step-2, rebooted your EXPLAIN to make the setting take effect, and you should be able to see PFC running message 2.2.
2.2.
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.