Installation Guide

Z5708-U
“Nano Pint
®
” 1/8 gpf, EcoVantage
®
,
Ultra Low Consumption Urinal
EcoVantage
®
is registered trademarks of Zurn Industries, LLC.
Rev. A Date: 4/18/2017
Dwg. No. 312076 Product No. Z5708-U
ZURN INDUSTRIES, LLC.
♦♦
♦♦
♦ COMMERCIAL BRASS OPERATION
♦♦
♦♦
♦ 5900 ELWIN BUCHANAN DRIVE
♦♦
♦♦
♦ SANFORD NC 27330
Phone: [phone]
♦♦
♦♦
♦ Fax: [phone]
♦♦
♦♦
♦ World Wide Web: www.zurn.com
In Canada: ZURN INDUSTRIES LIMITED
♦♦
♦♦
♦ 7900 Goreway Drive Unit 10
♦♦
♦♦
♦ Brampton, Ontario L6T5W6
♦♦
♦♦
♦ Phone: [phone] Fax: [phone]
The Pint
®
is registered trademarks of Zurn Industries, LLC.
TAG
ENGINEERING SPECIFICATION:
Z5708-U EcoVantage
®
Urinal- Vitreous china urinal is
supplied with retrofit bracket, 3/4" top spud, 2" outlet con-
nection, and vandal resistant outlet strainer.
Z5708-U
• Zurn One ultra low consumption urinal designed for
optimal performance between Zurn fixture and Zurn flush
valve to save water while exceeding industry performance
standards.
• 1/8 gallons per flush [0.5 Liters per flush]
• Vitreous china
• Designed to retrofit 4 bolt pattern urinals with no work
behind the finished wall required in most installations
• High efficiency washout flushing action
• Over 88% water savings over standard 1.0 gpf
[4.0 Lpf] system
• Pressure compensating internal flow regulator
• 3/4” top spud
• 2” I.P.S. outlet flange and rubber gasket
with integral trap
• 14” extended rim for handicap compliance
when installed at proper height
• Assembled with vandal resistant outlet strainer
• Shipping weight: 24lbs.
Z5708-U SERIES
This space is for Architectural/engineering Approval
Fixture dimensions meet ANSI/ASME standards
A112.19.2 and CAN/CSA B45 requirements.
Meets the American Disabilities Guidelines and ANSI
A117.1 requirements when urinal is installed 17"
[432 mm] from finished floor.
These dimensions and specifications are subject to
change without notice.
This product should be used with a
WaterSense labeled counterpart with a
compatible flush volume to ensure that the
entire system meets the requirements for