Measurement Guide

Zurn Commercial Brass Division
5900 Elwin Buchanan Drive, Sanford, NC 27330
Phone: [phone] Fax: [phone]
Zurn Retrofit Measurement Sheet for Urinals
Replace your current urinal with a Zurn Pint Ultra Low Consumption Urinal
1. Fill in the required critical measurements below from your existing urinal
2. Contact Zurn to confirm the Zurn Pint urinal that will best fit your installation
3. Begin saving water with every flush!!!
Current Urinal Dimensions * Above Denotes Critical Dimension
A _________ (floor to outlet)
B _________ (floor to rim)
C _________ (floor to top of urinal)
D _________ (floor to center of incoming water supply)
E _________ (center of water stop to center of vacuum breaker)
F _________ (width of urinal at largest point)
G _________ (overall length of urinal)
H _________ (width between outlet studs)
I _________ (finished wall to center of inlet spud)
Who was the current urinal manufactured by? ____________________________
Is the current urinal model number known? _______________________________
How many urinals will be replaced? ____________________________________
Is there a desired rim height tolerance? (Dimension ‘B’ Above) ______________
Additional notes or special requirements to meet local your
plumbing codes, please list.
_______________________________________________
_______________________________________________
_______________________________________________