User Guide

ManualsBrandsZurn ManualsPlumbing Product1.6 gal. Aquaflush Plus Exposed Closet Dual Flush Valve

Page 1

Aquaflush

Z6000 Series

Aquaflush Exposed Flushometer

Installation, Operation,

Maintenance, and Parts Manual

atented and Patents Pending

LIMITED WARRANTY

All goods sold hereunder are warranted to be free from defects in material and factory workmanship for a period of three years from the date of

purchase. Decorative finishes warranted for one year. We will replace at no cost goods that prove defective provided we are notified in writing of such

defect and the goods are returned to us prepaid at Sanford, NC, with evidence that they have been properly maintained and used in accor dance with

instruc tions. We shall not be responsible for any labor charges or any loss, injury or damages whatsoever, including incidental or conse quen tial

damages. The sole and exclusive remedy shall be limited to the replacement of the defective goods. Before installation and use, the purchaser shall

determine the suitability of the product for his intended use and the purchaser assumes all risk and liability whatever in connection therewith. Where

permitted by law, the implied warranty of merchantability is expressly excluded. If the products sold hereunder are “consumer products,” the implied

warranty of merchantability is limited to a period of three years and shall be limited solely to the replacement of the defective goods. All weights

stated in our catalogs and lists are approximate and are not guaranteed.

Aquaflush

Exposed

Closet/Urinal Systems

Z6000

Z6000PL-HET

Z6001

Z6003

Z6003PL-ULF

Z6010

Z6014

Z6017

Z6096

Z6099

Z6000

Z6003



ADA



ADA

Summary of content (8 pages)

PAGE 1
Aquaflush Z6000 Series ® Aquaflush Exposed Flushometer Installation, Operation, Maintenance, and Parts Manual Patented and Patents Pending Z6000 ADA Aquaflush® Exposed Closet/Urinal Systems Z6000 Z6000PL-HET Z6001 Z6003 Z6003PL-ULF Z6010 Z6014 Z6017 Z6096 Z6099 Z6003 ADA LIMITED WARRANTY All goods sold hereunder are warranted to be free from defects in material and factory workmanship for a period of three years from the date of purchase. Decorative finishes warranted for one year.
PAGE 2
Aquaflush® Rough-In, Product Specification, Models and Options ENGINEERING SPECIFICATION: ZURN Aquaflush Exposed Closet Flush Valve – Exposed, quiet diaphragm-type, chrome-plated flushometer valve with a polished exterior. Complete with a chloramine resistant, dual seal diaphragm with a clog resistant by-pass.
PAGE 3
Sweat Solder Adaptor Installation Instructions Important: • All plumbing is to be installed according to state and local codes and regulations. • Water supply lines need to allow proper water flow for each fixture. • Flush all lines of any debris before making connections. • Do not use pipe sealant or plumbing grease on any fitting other then the control stop inlet. STEP NO. 3 Measure from finished wall to first thread of adapter for length of chrome tube. Cut chrome tube this length ‘x’.
PAGE 4
Aquaflush® Installation Instructions 1. Install stop valve assembly using proper size supply escutcheon 3. Insert the flush valve tailpiece into the stop valve and hand and sweat solder adapter kit if applicable (see 1). Thread sealing compounds should be used on male NPT threads only. tighten the lock nut to the stop valve. Plumb the entire unit (see 3). 1 3 2.
PAGE 5
Aquaflush® Installation Instructions 6. When all flush valves are connected to the fixtures and water pressure is available, it is recommended that the supply piping be flushed to remove dirt, pipe chips, etc. from system. Before the water is turned on, be sure all stop valves to the flush valves are closed off tight. The stop valves can be opened and closed by using the adjusting screw located at the center of the stop valve cap, behind the stop snap cap screw cover if already installed (see 6a).
PAGE 6
Aquaflush® Exposed Repair Kits Parts Identification 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34. 35. 36.
PAGE 7
Aquaflush® Trouble Shooting Guide Problem Valve will not operate. Insufficient volume of water to adequately siphon fixture. Flush valve shuts off too quickly. Cause* 1.) Stop valve is closed. 1.) Open stop valve. 2.) Supply valve is closed. 2.) Open supply valve. 1.) Stop valve is not open enough. 2.) Urinal trip mechanism installed in wrong kit, urinal for closet. 3.) Insufficient volume or pressure at supply. 1.) Open stop valve for desired volume of water. 2.
PAGE 8
ZURN INDUSTRIES, LLC COMMERCIAL BRASS OPERATION, 5900 ELWIN BUCHANAN DRIVE, SANFORD, NC, U.S.A. 27330 PHONE: 1-800-997-3876 FAX: 919/775-3541 www.zurn.com ZURN INDUSTRIES LIMITED 3544 NASHUA DRIVE, MISSISSAUGA, ONTARIO L4V 1L2 PHONE: 905/405-8272 FAX: 905/405-1292 © 2014 Zurn Industries, LLC Printed in the U.S.A. Form No. FV250, Rev.