Installation Guide

FV563 Rev. F 5/9/2016

Page 9

Loosening screw will cause sensor assembly to back out of spout

body. It may be necessary to push cable from connector end to

aid in sensor assembly removal. Firmly press into pocket and

tighten screw. Sensor connector may need to be turned horizon-

tally when first inserting into the spout.

With spout disengaged, sensor assembly can now be removed

by loosening the center screw with supplied M3 Allen wrench.

With assembly removed, you can now install new assembly and

reassemble your spout.

Sensor Assembly Replacement

To service solenoid use Phillips head screw driver to remove

the screws on both sides of the electronics box.

With screws removed, the electronics box can slide off and

allow access to the solenoid for service.

Accessing the Solenoid

Use supplied 3/32” hex wrench to loosen set screw. Screw will

retract into the base to eliminate loss. Using the same hex wrench,

depress the ball detent to release spout from base.

Lift spout and pull sensor cable through deck and base.

Align spout so that the ball detent is between the 2 holes. Press

down and turn clockwise. Use hex wrench to back set screw out

to secure spout.

To reinstall faucet, first drop sensor cable of new spout through

the front of the base. Lower spout onto base inserting base nipple

into spout port.

To replace spout body, you must first turn water off, then remove spout with sensor cable.

Note location of set screw and spring lock.

Spout Replacement

SPRING LOCK

SIDE

Before removing the spout, disconnect the sensor cable below

the deck so that the cable head can be pulled up through the deck.

*Take care to press the locking mechanism in prior to discon-

necting sensor cable. PULLING APART WITHOUT PRESSING

IN THE LOCK MAY DAMAGE THE SENSOR OR CONTROLLER

CABLES.

SET SCREW

SIDE