Installation Guide

FV563 Rev. F 5/9/2016

Page 4

Spout Installation - Step 1

Electronics Module Installation - Step 2

1.1. Carefully screw aerator into spout using included tool.

Take care to not pinch blue o-ring

1.2.Install spout to sink using spout base gasket, plastic

mounting washer, star washer and mounting nut (and cover plate

for versions that are included).

1.3. Ensure that slot in plastic washer is facing forward.

2.1. Assemble the electronics module

2.1a. For non-IM assembly, connect filter to bottom of electronics

module.

Sensor cable should not pass through plastic mounting

washer.

NOTE: Before installation, turn off water supplies to existing faucet and remove faucet if replacing an existing

device. Clean the faucet basin and clear away debris. Flush all supply lines before connecting the faucet. Failure

to do so may result in debris clogging the inlets and/or internal control and mixing valve

2.1b. For IM assembly, connect Y adapter (A) and two filters (B)

to the electronics modules(C)(D). The two electronics

modules are interchangeable on hot and cold lines

1.2a. Z6955 version – secure two additional bolts using the

provided washers and nuts.